Search models, users, collections, and posts
Volvo P2 (S60, V70, S80) Vent 52mm Gauge Adapter
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
Open in Bambu Studio
Boost
21
58
1
0
69
27
Released
Description
This adapter allows you to easily center a 52mm gauge in the driver's side air vent. There is a firewall bypass behind the dash in this area which makes it a convenient place to mount a gauge.
Notes:
- This will require you to permanently remove the louvres in your vent, so it is best to test on a junkyard one.
- It is recommended to glue the adapter into the frame of the vent - the dowels are for alignment only, and are not sufficient for permanently holding weight.
- It is a tight fit by design, it should snap into place. Minor sanding may be needed depending on the plastic you print it with.
- The hole is exactly 52mm with extra border to allow for sanding for a perfect fit.
- For RHD, mirror the file.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)