Pneumatic/Hydraulic tube fixture 12/10/8/6/4mm

This is a fixture for routing industrial pneumatic/hydraulic PE/PU tubes, which can also be used for water irrigation.
The fixture is designed to allow inserting and removing tubes easily and multiple times.  

Glue or tape it in position, then squeeze the tube slightly and press it - at an angle - into the fixture on one side. After that, you should be able to press in the tube along the rest of the fixture.

The tubes are pressed in and have a relatively tight fit (-0.2 mm clearance). 
Designed for PETG (PLA likely is a bit too rigid).

The model set provides an array of variants, which differ in three properties:

• The fixture can be attached either by adhesive tape (model with flat bottom) or with glue (model with grooved bottom). 
• There are models for short (25mm) and long (50mm) fixtures in all mentioned variants.
• Models for the most common tube sizes: 12/10/8/6/4mm (outer diameter)

The print profile organizes the variants in plates per tube size. Print a plate for trying the fixture, then go and fill up a plate with your favourite piece!


If you want/need to make more fine grained adjustments, check out the Onshape model:
https://cad.onshape.com/documents/b9f8398e43af09212476c522/w/2dac051fec799f6f82724a5e/e/d67a7f4356b70a5cb33af8ec?renderMode=0&uiState=68b493b2655d9beb3e108b32