Search models, users, collections, and posts
Pocket Schematic Maker - Circuit Stencils & Ruler
IP Report
Print Profile(2)
PocketSM, Normal Stencil (0.7-0.5mm Pencil Lead)
Designer
32 min
1 plate
PocketSM, Thin Stencil, (0.3-0.2mm Pencil Lead)
Designer
32 min
1 plate
Open in Bambu Studio
Boost
1063
2357
60
23
1.2 k
785
Released
Description
Pocket ruler with stencils to draw perfect and quick circuit schematics!
- NO AMS Required!
- 15cm long, fits in most pencil cases
- Metric and Imperial markings
Available Stencils:
- Resistor
- Generic Load/Impedance
- Inductor
- Capacitor
- Diode
- Independent Source (Circle)
- Dependent Source (Rhombus)
- Op-Amp (Triangle)
- BJT & FET Transistors
- Generic Device Rectangle
Printing Notes:
- Use the Normal stencil for ≥0.5mm pencil leads, and the Thin model for ≤0.3mm leads
- Peel off the stencil CAREFULLY from the build plate, as it is very thin and flexible.
- Perform 2 manual filament swaps if you do not have an AMS
- Adjust X-Y Hole compensation if your stencil holes are too narrow or wide
Boost Me (for free)
Want to see more stencils? Maybe ones for digital logic or mechanical design? Please support my model!
Changelog:
- August 31st, 2025
- Updated BJT to have collector and emitter legs for alignment
- Updated diode to remove cathode gap
- September 1st, 2025
- Reduced top layer flow for better top surface quality
- Reverted diode change
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (60)