Scale Yeti Cooler - 24th, 18th, 10th, 6th, 4th

In the project files you'll find pre-painted and pre-scaled mini Yeti coolers, with several custom enhancements I've made. 

For the hinge mechanism use either wire or rods to use as a hinge pin, depending on which size you choose. For the 6th scale, a bit of filament cut to length works well for the hinge pin. You can glue the ends of the holes shut if you're worried about the pin coming out.

You can also use some clear silica gel desiccant to make scale “ice”.

This is a fairly challenging print. A Supertack plate, or the 3rd party equivalent of one, is required. Otherwise, they warp like nobody's business.

Significant modifications have been made to this Yeti cooler, including but not limited to:

• Pre-painted the model.
• Pre-scaled the model in various sizes.
• Added complete hinge mechanism.
• Added voids for magnets to hold the lid shut, with pauses set up so you can add the magnets (only on the larger scales).
• Filled in the upper lip around the inside edge, making it significantly easier to print and eliminating clean up of the area (excluding 24th scale).
• Added “YETI” and “45” text.
• Added drain detail to side.
• Added pass-through slots under each handle to use as tie-down anchor points (excluding 1/24th and 1/18th scales).
• For 6th and 4th scale added front trapezoidal detail found on actual Yeti Tundras.
• For 6th and 4th scale, added holes for locks to the front corners.

Magnets (optional):

1/4th - 8x3mm

1/6th - 5x2mm

1/10th - 4x2mm

Available accessories to go with your Yeti coolers:

Mini Yeti Ice packs

Mini Yeti Rambler mug - 30 oz.

Mini Yeti Rambler mug - 20 oz.