Measuring bridge / depth stop for 150 mm calipers
Print Profile(1)
Bill of Materials
- M4 Sechskantmutter x 1:
- M4 X 10 Zylinderkopf oder Inbusschraube x 1: Oder eine M4 x 16 Senkkopfschraube
Description
Attached is a measuring bridge / depth stop that should fit all common 150 mm calipers with a 16x4mm profile
I tested it with 4 calipers as shown in the pictures
2 high-priced Mitutoyo, one Mauser Digital, and a 4€ plastic caliper from Ali
Clamping is done with an M4 screw held by a hex nut
No insert or tap is needed
Printing is done WITHOUT supports
When using high-quality calipers, I recommend using a clamping screw made of brass or plastic
The clamping screw should also only be tightened lightly
I assume no liability for damage to calipers caused by improper use of my measuring bridge
In the print profile, you will find 3 additional print plates, each with a knurled knob for countersunk head,
cylinder head, and Allen head
This knurled knob can simply be glued to the corresponding DIN screw if necessary
No high forces need to be transmitted
I printed my measuring bridge with PLA, but if I had to print it again,
I would probably choose PETG
Have fun with this model
I'm just starting to publish my designs.
Therefore, I would be very happy about a Like or even a Boost.
Boost Me (for free)
I'm old and I need the money. :-)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)