Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
3.6 h
1 plate
Open in Bambu Studio
Boost
48
119
3
1
122
53
Released
Description
Strong guitar support that print in two parts so that the print line can be in the coorect orientation for the part to be strong.
Two parts should be glued together. In case of glue failure the screw that you will put in your wall will go through the two halves so it should be good.
We do not want our guitar to fall on the floor guys!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)