Search models, users, collections, and posts
Twist In Quest 3 Controller Rig Mount
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 20% infill
Designer
56 min
1 plate
Open in Bambu Studio
Boost
40
120
11
6
179
137
Released
Description
Quest 3 Sim Rig Clip Mount (Twist In. No Screws Needed)
This is a remix of Quest 3 Wall Mount
I adapted it to hold the Quest 3 controllers directly on aluminum profile sim rigs. No screws required; just 3D print, twist it onto the profile, and it locks in place. Keeps your controllers secure and always within reach.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)