Search models, users, collections, and posts
Straightener, Blow dryer holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
212
650
33
4
602
326
Released
Bill of Materials
Bambu Filaments
Select all
Description
Simple holder for Blow-dryer and straightener
Printed on a X1C in Bambu studio with standard loaded up settings. I did add supports, haven't tried it without. You can tell in the cover picture of the blow-dryer ring the notorious variable layer height got me. I didn't adjust the VLH for my print, but you could and most likely will smooth it up a bit. I also positioned it on its back for the print. I will probably not be re-doing this print unless anyone really wants me to incorporate some changes. Filament I used was Bambu PLA matte ash grey.
Boost Me (for free)
I have no idea what boosting does cause it's my first time.
My fiancé asked me to make this up and she's getting good use out of it. If you or your girl enjoys it shoot me a like.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (33)