Leafeon Chibi

The Leafeon Chibi model has arrived

Thank you very much for your support of this Chibi series

First of all, I want to ask you about this model. Leafeon's ears and tail usually have two shades of green. I made it with only one shade of green because I don't have such a light green. I want to ask you, do you want me to upload a version with both colors? It's not difficult to edit, so if you want it, just ask for it

ASSEMBLY: Assembly is important for it to look good

The Ears: I recommend gluing the brown part to the green part first, then fitting it into its respective ear. There shouldn't be a problem with fitting it. Before completely fitting it, add a few drops of glue

LEAVES: The leaf pieces for both the legs and the back can be glued at whatever height you prefer. I tried to leave a slight relief to indicate where they should go, but it's not very noticeable. I also didn't want to add a connector because, being such small pieces, they were likely to fail. The leaf on the back is modeled to fit between the back and the head; a small mark should be visible

THE NOSE: A small notch should be visible on the snout to indicate where the nose should go. As with the leaves, I didn't want to add a connector due to its probability of failing

You have access to a multi-part profile and a single-piece painted profile for AMS. If you want to print it in a single color, just remove all filaments from the filament palette, and the piece should be a single color. I will try to upload a profile for A1 mini

Again, thank you very much for your support. If you ever have problems printing, fitting pieces, or in general, I am always available to help you

MEW CHIBI IS NOW AVAILABLE: https://makerworld.com/en/models/2001608-mew-chibi#profileId-2155245

If you want to sell physical prints of my designs, you can get a commercial license on Patreon.
You can also support me there so I can keep creating and uploading new models: www.patreon.com/cw/Atseini 💙