Voron 0.2 Anti-vibration feet

To decouple the printer, I wanted to mount anti-vibration feet

The original Bambu Lab anti-vibration feet are far too soft, there could even be a risk of the printer tipping over, so I got significantly harder feet:

https://www.amazon.de/dp/B0CQRDWN2W?ref=ppx_yo2ov_dt_b_fed_asin_title

For this, I had to design new adapters suitable for the Voron 0.2 so that it stands much better and the printer does not oscillate nearly as much

The tolerances are designed so that the rubber parts should fit snugly, CA can be used optionally

Unfortunately, the feet have a disadvantage: during the speed test (800mm/s @ 22K accel), the printer moves a bit on the table

For this, I have optionally prepared additional feet which have a silicone pad on the underside:

amazon.de/dp/B0CWQ26SMP?ref=ppx_yo2ov_dt_b_fed_asin_title

During normal printing, the printer now stands perfectly, but during the speed test there are still slight movements on the table

I'm still working on this, maybe smaller pads will help for a better point load

WORK IN PROGRESS - If anyone has tips and ideas, please share them!