Camper van gas bottle spray can holder

When you buy disposable gas cans they usually come packaged in packs of 4.  Once you have taken one out the rest just fall about all over the place.  If you have a rock ‘n’ roll bed in your camper van you may have noticed there is an exact can sized gap between the bottom of the bed base and the top of the frame.  You can wedge a 4-pack in here until you open the packaging then they all just fly about.  Well not any more!

This model is screwed to the underside of the bed base.  Disposable cans click into the arms, slide back into the stop and are held in place by the small clip at the front.

To remove, pull the front of the can down a bit which releases the front clip, slide it out towards you then pull down once clear of the bed framework.

These will also take standard size spray cans (without the lid) and anything else that is the same size.  If you have other unused space these can also be used upright to use up available space.

I printed in PET-G using 0.2mm and 6 walls to make sure it was good and solid. With 2 walls and infill it snapped on the holding arms after a few uses. A #4 screw fits Niceley into the holes.   You can fit 2 at a time onto an A1 mini bed and take just over an hour each to print. Suggest you just do 1 first to make sure it fits your space and can.  I have tested with genuine camping gaz and cheap homebargain cartridges and works well with both. 

Please leave a comment if you found this useful or have any improvements to recommend. 

Happy camping. 

Oh and checkout by camping cooker wind screen supports if your support blows over in the wind.  https://makerworld.com/en/models/1466116-camping-stove-windshield-support-for-folding-table#profileId-1529433