Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, AMS
Designer
2.3 h
2 plates
Open in Bambu Studio
Boost
340
1021
39
7
761
441
Released
Description
Content has been automatically translated.
English
I have remixed the wonderful beer bottle helmet model and replaced the helmet with an NVA M56 helmet from the GDR.
Print settings
You can use the print profile (3mf) with pre-configured settings and colored hand for AMS usage.
Arm with helmet + pin
- Default 0.20mm profile
- Seam position: Back
- Wall loops: 3
- Infill pattern: Gyroid
- Support: Enabled
Bottle shoulder ring (EU bottle 70mm)
- Default 0.20mm profile
- Wall loops: 3
- Infill density: 30%
- Infill pattern: Gyroid
- Support: Disabled
Many thanks to the creative creators of the original models:
- https://makerworld.com/de/models/52584-bottle-helmet-beer-helm-flaschenhalter-bier
- https://www.thingiverse.com/thing:6654181
German
I have remixed the wonderful beer bottle helmet model and replaced the helmet with an NVA M56 helmet from the GDR.
Print settings
You can use the print profile (3mf) with pre-configured settings and colored hand for AMS usage.
Arm with shoulder + pin
- Default 0.20mm profile
- Seam position: Back
- Wall loops: 3
- Infill pattern: Gyroid
- Support: Enabled
Bottle shoulder ring (EU bottle 70mm)
- Default 0.20mm profile
- Wall loops: 2
- Infill density: 30%
- Infill pattern: Gyroid
- Support: Disabled
Many thanks to the creative creators of the original models:
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (39)