Search models, users, collections, and posts
Airsoft BB Speedloader storage container
IP Report
GIF
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
2 plates
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
8 h
1 plate
Open in Bambu Studio
Boost
162
326
18
7
433
237
Released
Bill of Materials
Bambu Filaments
Select all
List other parts
- 1.5 Wooden Screw x 2: Used for closing the chassis
- 6mm Metal spring with diameter of 3mm x 1: Pen springs work but are not reccomended due to their weak strength
- 1-2mm Thin metal nail x 1: Used for the cap
Description
I've designed a simple and efficient, spring-loaded, 90% 3D-printed Airsoft BB speed-loader. This allows you to load BBs very quickly and efficiently.
From what I've seen, this is the only 3D design of such a device, at least on MakerWorld.
The cap closes and opens with a bit of difficulty after first assembly due to Its proximity to the enclosure screw shaft, but It will loosen up.
You will need:
- (x2) 1.5cm thin wood screws
- (x1) 2.5-3.0 cm spring with a diameter of about 5-6mm
- (x1) very thin nail to use as a hinge for the cap
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (18)