Fantasy Football Lombardi Trophy

This is a remix of MCDeltaT's Lombardi Fantasy Football Trophy. I redesigned the FFL Logo to be multicolor as well as the Trophy base to have a hollow cavity to add weight. 

Original text in model is “2025 Fantasy Football” on top and “League Champion” on the bottom. If you would like to change it, follow the instructions below:

1. NOTE: The latest update to Bambu Studio seems to have made changing the text much more difficult. It is causing the text to move around after you change it. I have no idea why this is happening, but I have included a temporary fix in the steps below
2. Click on Objects button
3. Select Plate 1
4. Click on text_shape for the text you want to change

   1. 

5. Click on the Move button in top toolbar
6. Take a screenshot or make note of the X/Y/Z positions

   1. 

7. Click on Text button in top right of the toolbar
8. Change text in Input Text field

   1. 

9. More than likely the Bold option will be deselected after you click enter or click out of the change text tool, so make sure to reselect it 
10. Also, more than likely the text will move. To fix this, reselect the text_shape and then press the Move button in the toolbar. Enter the X/Y/Z from step 6 above. This will move the text back to the original location.
11. This same method can be used for the lower textbox

The FFL Logo is designed for print efficiency. It only changes filaments two times. 

The base is designed with a hollow cavity so that weight can be added after being printed. It was too difficult to break apart the tree support, so I just left it inside. I added sand into the hollow cavity (after printing of course) to add some mass.

Assembly should be fairly self explanatory. First, glue the FFL Logo to the Trophy Base. There is a small hole in both the FFL Logo and Trophy Base to allow for a small printed dowel to be inserted and glued to make lining up the logo easier. I recommend gluing the dowel in the FFL Logo first, allowing it to dry and then glue both to the front of the Trophy Base. Next, glue the two larger dowels into one of the football halves, then glue both halves together taking special care to line them up perfectly. Then, after filling the hollow cavity if you so desire, apply glue to the square post and surrounding curved portion where the ball will sit. 

Filaments Used:

• Silver Silk PLA
  • For Trophy Base
  • Note that I slowed the Outer Wall speed down to 30mm/s for a cleaner and shinier print with Silk PLA. This can be sped up if you don't plane to use Silk PLA.
• eSun Cold White PLA+
  • Highly recommend as it does not allow bleed through of other colors
  • For White portion of FFL Logo
• Blue PLA
  • For Blue portion of FFL Logo
• Red PLA
  • For Red portion of FFL Logo