Cyber-wallet (wallet with key holder)

Hello everyone again!!

This time I bring a pocket wallet with capacity for 5 cards, 2 keys, and a money clip, with aesthetics inspired by the cyberpunk universe.

The wallet is printed in separate pieces and everything is assembled using 6 M2 12mm long screws. The assembly is very simple, as can be seen in the image.

The keys must have dimensions of 24 mm wide and a thickness of 2.4 - 2.6 mm. The most important thing is the thickness, as they are held by friction, and if they are thinner, they will fall out on their own. It is also important that both keys are of the same thickness, as if one is thicker, it will slightly deform the cover and cause the thinner one to slip out. To prevent this, you can always put a little superglue on the ridge that separates both key compartments and glue it to the base (see image below).

And little more to add, I hope you enjoy the model and find it useful. If someone needs another module instead of the key one, I could try to design it, such as a coin compartment, or for an AirTag-like tracker, etc. If I see people asking for it in the comments, I will try to design it.

Thank you for reading this far.

Have a good day.

P.S.: If you print it, I encourage you to comment on your impressions of the model, upload photos of the result, and help me with a boost to continue creating more models.