This came out really well. For some reason the black bled into the white on the face a little bit.

some color bleeding and hand broke off

fantastic, printed great

Un petit bijou

nice print a little bleeding from the black that is fine with touch up marker

I printed 5 of these using print to infill (not the designer's choice but rather mine), 0.16mm, print to support, and optimized Gcode to save filament. The only regret I have is the print to infill as I think in a couple of spots the white didn't cover over the mixed infill enough. Luckily I have an acrylic white paint marker and was able to touch them up good enough. Thank you for this print! I was able to give it to my kids and their friend right after seeing the new ghost buster's movie.

Had some black show up behind the white around his eyes. Unsure if that's my issue. I'm nee to 3D printing

It printed great, other than you can see the black of the eyes coming through around the white on top.

nostalgia!

this came out almost perfect ( it was my fault) I selected to purge into infill so it made the face kind of dark.