Table fountain various designs
Print Profile(3)



Description
Update:
A new print profile is online
A fountain that is easy to set up and where the fountain top can be exchanged I will design various tops over time
You only need a small pump such as the https://amzn.eu/d/fQNEwgH
and a suitable hose with outer diameter 10mm and inner diameter 8mm, for example https://amzn.eu/d/jkohv49
Shorten the hose to the appropriate length, connect the pump with the hose to the connection on the fountain top Place the top onto the water tank so that the L-shaped supports fit into the corresponding cutouts Fill with approximately 2L of water and connect the pump You can adjust the pump performance on the pump so that not too much or too little water is delivered
If the water tank should not be watertight, spray the inside with several coats of clear lacquer
In my multiple test prints, all water tanks were watertight
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
















Comment & Rating (1)