Print Profile(3)
Description
Boost Me (for free)
If you like my designs, please consider boosting me to show your support!
***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***
## These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##
No more guessing which chain switch to pull for the fan or the light.
Simple print and pretty easy assembly.
**Change log 9/2/25** improved bulb and light clips to help prevent breakage per request
Set up for print per object 2 plates but you can print individually if you prefer. I test fit it for the A1 mini plates as well and it should fit all printers as is.
Removing support from the bulb and the light is easiest done by gently twisting and rocking the support it will eventually loosen and slide or twist right off
Remove the old chains from your current pulls and feed them through the holes, then snap in the bulb and light pieces to cover them. (see pics)
The clips are tiny but you will most likely need to print them to replace the larger existing clips included on most fans. Just slide them under the first ball and lower it and chain into the hole as shown in pics
Membership
Join my Commercial Membership and enjoy selling rights for all of my models for as low as $3 per month.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (93)