CannonMist - The Fog Cannon Humidifier

☁️🏴☠️ CannonMist - The Fog Cannon Humidifier

A playful humidifier shaped like a miniature cannon.
Load the filter from the back, connect the mist module, and watch it fire clouds through the barrel like a blast of smoke.
 

📦 Parts List

• Cannon Barrel
• Mesh Cover (optional)
• Fog Directioner (target-shaped ring for a diffused cloud effect)
• Bottom Rack
• PCB Drawer
• Two Wheels
• Mist Module (from Aliexpress, USB-C powered)

🖨️ Print Instructions

• Printed in PLA.
• Supports needed:
  • Rack (underside)
  • Fog Directioner
  • Barrel (bottom part only, if any)

🔧 Assembly Instructions

1. Thread the mist module cable through the barrel and rack, then connect it to the PCB.
2. Secure the module inside the barrel with a drop of hot glue.
3. Insert the PCB into its drawer and slide into place.
4. Snap the barrel onto the rack.
5. Attach the wheels.
6. To activate:
   • Soak the filter in water (ensure it’s wet but not dripping).
   • Push the filter through the back of the barrel until snug inside the module.
   • Clear the sleeve path if tight (a screwdriver works well).
   • Place the mesh and fog directioner at the barrel’s opening (optional).

🌿 Functional Notes

• On first use with a freshly wet filter, condensation may form as droplets on the fog directioner. Handle with care.
• The fog directioner softens the mist into a cloud-like plume rather than a sharp spray.
• No moving parts beyond the mist module; just plug in USB-C power and let the cannon smoke.

------------------------------------------------------------------------------------------------------

Every model is originally designed from scratch, rigorously 3D printed, and thoroughly tested to perfection by Omri Hillel. All rights reserved. Unauthorized duplication, modification, or commercial distribution without a proper license is strictly prohibited.