StarCraft - Hellbat - Exquisite and Fun - Fidget Assembly

【Follow us, and we'll send you the latest designs as soon as they're available!】

Please make sure to apply glue or heat bed spray before printing. Don't let the first layer stick poorly or "fall off", which may result in incomplete or messy prints. If you're a beginner, we recommend you check out the "Tips for Beginners" at the bottom.

Apply glue to the build plate, then print

This time, I tried color separation for parts and used a small amount of glue to achieve a cooler appearance Previous works always adhered to no supports, no glue, and no hardware, but this sacrifices multicolor parts, and balancing all three results in very low design efficiency However, no supports is still my current persistence

If you think using a small amount of glue improves the effect of multicolor parts better than before, please let me know in the comments, thanks

For the effect in the poster, I did some light coloring with an "electroplating pen" and a "black pen" If you like it, you can try it (but be aware of layer line bleed-through)

Although my output is not high, I want to strive for perfection as much as possible I hope everyone likes and supports it as always

Welcome to join the VX fan group to participate in design discussions and share experiences: xiangbobomw

Installation Instructions - On mobile, tap to load GIF animation

Filament Recommendation: PETG Matte (for better shock absorption), Metal, Silk try to avoid using regular PETG as the surface detail and embossed effect are not good