Search models, users, collections, and posts
Intend Hero Lower Guards 150 mm
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
19
40
2
0
35
15
Released
Description
Content has been automatically translated.
These are protectors for the suspension fork of Intend's Hero model with 150 mm travel. I attached the protectors to the fork with thin tape. Warning, the protectors are without the cutouts, contrary to the pictures.
The model weighs approximately 40 gr without the cutouts and has no noticeable effect on the fork's performance ;o)
I recommend printing the protectors with PETG filament, as PLA deforms in the sun
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)