Universal Bicycle Lamp Holder under SP Connect

This is a universal bicycle lamp holder that can be screwed under the SP Connect mount on the bike

Please check if this is also the case with your mount

My "SPC/SPC+ Handle Bar Mount Pro" has 4 threaded holes below the round plate that can be used (e.g. also for GoPro mounts etc)

The diameter for the mount is 25mm and should work with any battery-powered bicycle lamp that has a round mount with an elastic strap at the back

The distance under the SP Connect mount is then only 13mm

If a bicycle lamp with a middle elastic strap is to be attached (e.g. Sigma and similar), please use one of the 4 plates in the 2nd print profile These are pulled further down (from 25mm to 40mm) and the bicycle lamp can be clamped from below (see photos where a Sigma lamp hangs on a 35mm holder)

Other lengths or widths gladly on request

The screws for attachment (I think they are 2.5 x 10mm countersunk) were already included with my SP Connect mount

Due to possible sun exposure and potential heat, it is better to print with PETG or other temperature-resistant filaments

I will first test how long the PLA+ lasts ;-)