Fractal Ridge Bracket for Linkup PCIe 5.0 Riser

Update: LinkUp has a new version of the riser cable where the red plastic cable relief interferes with the original V1 bracket. Use the new V2 model if you have the new riser cable. If you're not sure which one you have, V2 will work with both versions of the riser cable

This bracket allows you to use a Linkup PCIe 5.0 (5cm) riser cable in your Fractal Design Ridge case. Recommended to print in a stiff, heat resistant filament (I used PPA-CF). 

Links to the riser cable:

Linkup Direct

Amazon 

Hardware required:

• 2 - M3 x 6mm brass inserts (4.0mm OD x 5.0mm Depth)
• 2 - M3 x 8mm screws and washers
• 2 - 6-32 screws (same used to fasten the original PCIe riser board to the GPU bracket)