IC Chip Pin Straightener Alignment Tool

Since my pin straightener for my microchips unfortunately broke,

I was looking for a print template for individual parts of the tool.

Since I couldn't find exact spare parts, but only alternative pin straighteners

for which corresponding screws would then be needed,

I simply measured and redrew this broken pin straightener precisely.

The screws and springs from the old pin straightener can be directly reused.

I intentionally completely omitted the indentations on the sides,

so there is no longer any need to fill these gaps.

I printed the tool with 0.08mm PLA to achieve an optimal fit,

whoever doesn't need it as precise can of course print with 0.2mm,

that should certainly be sufficient for the screws to fit as well (untested)

The model prints without supports.