Search models, users, collections, and posts
Sup Rear Fin
IP Report
Print Profile(1)
0.4 nozzle, 0.2mm layer, 6 walls, 25% infill
Designer
5.3 h
2 plates
Open in Bambu Studio
Boost
21
43
0
0
25
6
Released
Description
Rear Fin for SUP - Stand Up Paddle Board
My rear fell off the bridge so I made this replacement. The board is a generic no-name bought from Bauhaus.
The fin will go about 15 cm (6") deep and fit a slide in slot of about 18 cm (7"). On the second print plate is a small quick test model to see if the fin will fit your board.
A1 mini compatible.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)