Search models, users, collections, and posts
Satellite1 Dev FutureProofHomes minimal case V2
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
2 plates
Open in Bambu Studio
Boost
8
20
8
2
36
14
Released
Description
Case for FutureProofHomes Satellite1 Dev . This case is not the official one, it is designed to encase just the dev kit in the smallest size possible in case your using a external speaker. This is an updated version that does not require screws. The two pieces hold each other using two flaps. Buttons are integrated on the top piece, making this a two piece print.
When inserting the satellite1 you will need to move a little bit one of flaps outside, but be careful not to break it.
It is recommended to use transparent PLA for the leds but if you dont have, you can use white PLA. LED part is thin enough to allow light to be seen from the outside (But you will loose brightness).
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (8)