Search models, users, collections, and posts
Round Adjustable Furniture Leg
IP Report
Print Profile(2)
Set of four 0.24mm layer, 2 walls, 15% infill
8.8 h
1 plate
Set of four 0.24mm layer, 2 walls, 15% infill
7.8 h
1 plate
Open in Bambu Studio
Boost
139
373
5
3
146
90
Released
Description
Charming sphere legs that adjust with a twist for stability.
I designed these rounded legs as a playful way to up-cycle an old cutting board into a raised dog feeding station. Each leg has a threaded base that can be adjusted to level out any wobble. Fully tightened, they stand just under 3" tall and could also work for small display shelves or even a monitor stand
Additional parts needed:
- (x2) #6 cabinet hinge screws (per leg)
Prusa MK3+ print settings:
- 0.2mm layer height
- 0.6mm nozzle
- 3 Perimeters
- 10% infill (consider 25%+ for heavier loads)
- Polymaker Polyterra PLA Marble Brick Filament
If you're a fan of this design, please consider supporting me by leaving a tip!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)