Search models, users, collections, and posts
[Muzzle velocity 70+!!] Hand-pulled water gel blaster
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
16.2 h
4 plates
Open in Bambu Studio
Boost
3
3
0
0
16
0
Released
Description
Content has been automatically translated.
This is my first official model. If you like my model, please give me a boost! Thank you!
Scores 70+!!(Ensure good air seal, 1.8 spring)
Approximately 14 hours of printing!!
Installation instructions are below, take a look if interested
Disclaimer and Warning:
This toy poses certain risks. Before downloading, please understand local laws. Please use the materials specified in the 'Assembly Guide'. Blindly increasing performance may lead to unnecessary trouble
Strictly prohibited from firing at people and animals. Only for use by individuals aged 18 and above. Please use it in legally registered venues. Do not display it in public places. The author (me) and the platform are not responsible for any adverse effects caused by any user
Documentation (1)
Assembly Guide (1)
装配指南.pdf
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)