Search models, users, collections, and posts
Xkah Travel-Box 3.0
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
56.1 h
10 plates
Open in Bambu Studio
Boost
31
84
29
12
146
68
Released
Description
Content has been automatically translated.
Ahoy,
this is now the third version of my travel box for the XKAH with the original components and an additional battery
The box can be closed more securely than its predecessor and also has the function of being lockable
Have fun and always good vape
Regards
Box bottom and top part in 0.2 PLA
I printed the pod holders with a height of 1.6 This is where the threads ran most stably
The latches in PETG with 100% infill
Eight M3 x 25 mm screws are needed All are screwed into the filament No heat-set inserts needed
The side handle is attached under the screws for the clip-locking screws
The lid can be printed with a handle on top, or like the original without, allowing the use of the side handle So the preferred variant can be used here
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (29)