Maverick Quantum Flux XT Lower arms
Print Profile(1)
Description
Maverick Quantum Flux XT lower A-Arms
These dont look pretty, and I can add in the intricacies at a later date if desperately wanted, however I've done them flat to make them easier to print in PA etc. They are also thicker than standard for the same reason,
I have printed these in PLA for now, as my PA is wet and I do not need the arms at present, but was to show that the dimensions are correct.
There are 2 versions, one is enclosed pin and the other is the through pin. I've elected to do this instead of the screw hole as that screw is the weak point on the original arms and it would be very hard to print that nicely and retain any strength
You may need to run a 3mm drill bit through the pin holes after printing.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)