IR40 - Injora TRX4M Bed for Truggy Traxxas

I wanted to tidy up the rear of the IR40 body, and add some wiremanagement.

• Bed cover snaps on the front, and passes through the rollcage. No permanent mods needed.
• Wire management integrated into bottom side of bed cover for your wiring
• Tons of room to use reciever space if you're able to use a lay down style reciever or esc.

Also check out my other IR accessories such as sliders and chase racks.

Install Instructions:

Remove the two 0.050" screws that hold the rear rollcage on. Gently lift them up, and set the rollcage through the bed holes. Then replace the rollcage bars and re-attach the screws to fasten it to place.

Now gently snap the front over the existing sidebars of the bed. They will snap down securely. (this fit is tight so it wil stay in place, a silk PLA might not be able to work here).

Optional Step - Wire Management

There's two slots for Zip ties on the bottom so you can secure your wires for the tail lights, or whatever else you have back there. Reminder, this hinges with the body.