Search models, users, collections, and posts
YAPB - Yet Another Poop Bucket (with magnets)
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
4
3
2
0
13
8
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Bambu Filaments
Select all
Description
YAPB - Yet Another Poop Bucket (with magnets)
I couldn't find a Poop Bucket that I liked after trawling through 100's of them (most were too complex or used far too much filament) so I designed my own based on designs of others. My version has 1.26mm wall thickness (3 shells), uses 94g of filament and protrudes approx 50mm from the rear of the printer. It stands on the desk and has pockets for 4 Amazon 6mm x 3mm magnets but these aren't required if the bucket is not going to be knocked. The design clears a 200mm spool mounted on the factory external spool holder on the P1S and sits just under the poop chute when sitting on the desk.
EDIT Now with 6 magnets and hex pockets to press fit them in to!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)