Search models, users, collections, and posts
Wheel of Doom with Colored Pieces
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2.7 h
11 plates
Open in Bambu Studio
Boost
20
36
2
3
59
26
Released
Description
Updated Wheel of Doom with colored slices. All parts can be printed separately and then glued together. The individual slices are two parts with the bottom part being the color and the top part being the black logo. Alternatively, you can use a filament change at the color layer switch. Designed to print at 0.2mm layer height.
If the tolerances are too tight. adjust the percentages by 0.5-1% as needed. I suggest only resizing the x and y coordinates, not the z. Keep the thickness as is.
You must print the case and all other parts from the original model. I only changed the spinning wheel and have only provided those parts.
Big thanks to N0TBR3ND4 for the inspiration and model. Be sure to give them a boost.
Enjoy.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)