Search models, users, collections, and posts
1/8" Cutting/Sanding Jig for Halving 48T VEX Gears
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
7
7
0
0
13
6
Released
Bill of Materials
List other parts
- Vex High Strength Shaft x 1: Any length longer than 1.25"
- Low Profile High Strength Clamping Shaft Collar x 1: For securing the gear
- 48T Gear x 1:
Description
A jig for cutting/sanding an 1/8" off each side of a vex 48T gear in order to halve it
Sand down to level with the gear on one side. Then when sanding the other side insert the 1/8" shim between the Low Profile High Strength Clamping Shaft Collar and the gear. Then sand again to level
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)