LED Lamp Base w/ Flange & Single Cable Port

Made some small tweaks to the LED Lamp 001 base for a personal project.  Figured I'd share as a remix, maybe someone else will have a use for it.  This base is for LED Lamp Kit-001.

Tweaks:

• Added a 6mm deep, 67mm wide flange on the top of the lamp base cap to easier allow for press fitting or gluing lamp shades that were printed in spiral vase mode. Example 1 / Example 2
• Removed the second cable port because I thought it was unnecessary. 
• Added a modifier to the parts that makes some of the top surfaces use the "Concentric" pattern because it saves 86 seconds of printing time and I think it looks nicer.

Print Settings:

0.20mm Layer Height

Wall Generator:  Arachne 

As always, clean your build plate and dry/calibrate your filament for optimal results.

Happy printing, enjoy!