Segway Ninebot MAX G3 front wheel stand/dust trap

Introduction
This is a front wheel placement stand designed for the Segway Ninebot Max G3 electric scooter. The purpose of this stand is to hold the scooter upright while in storage, prevent dirt and dust from falling from the front wheel, and provide a stable grip on the wheel to maintain a secure vertical position.

Printing the Part
The stand consists of four separate pieces, each of which should be printed individually and then assembled using a strong adhesive. The prints shown in the example photos were made using PETG filament with a 0.4 mm nozzle and 0.16 mm layer height.

Disclaimer
This project was developed entirely on a voluntary basis and without any commercial intent. I am not responsible for any potential damage or issues that may occur to the scooter due to unforeseen design flaws or printing incompatibilities. Additionally, I am not liable for any accidents that may occur while using this stand to store your scooter, including falls or damage resulting from such incidents. Use this stand at your own risk.