IKEA PAX / HASVIK slide door stop.

I have a set of PAX / HASVIK sliding-door wardrobes from IKEA in my garage. Because the floor isn’t level, the doors tend to slide open on their own. The original design just doesn’t provide enough grip. 

I’ve seen other published solutions, but they’re either exact copies of the original or have design flaws that don’t really fix the issue.

This version uses reinforced retaining springs, giving it extra holding power. 

As a result, the doors stay shut much better — though it does make opening and closing them slightly harder. 

So far, it works exactly as intended, and I’ll keep an eye on its long-term performance. If needed, I’ll make further tweaks.

I recommend printing it in PETG since it’s less rigid, and you’ll need supports to print the part properly.