Print Profile(1)
Bill of Materials
Description
Description
This is the Bigger Fan version!!!
Small Version here: https://makerworld.com/en/models/1620991-fan-kit-for-ruff-land-kennels#profileId-1711119
The Kennel Fan Kit your Ruff Land Kennel (And your dog) has been waiting for!
This mounts a fan to the door of your Ruff land kennel utilizing the center hole.
Assembly:
1: Remove the screw caps from both sides of the fan.
2: Remove screws and retain for later use. Remove the fans Original Bracket
3: Place a little CA/Superglue and install the nut. This holds the nut in place during install
4: Install the fan into the 3D printed bracket using the original screws removed in step 2
5: mount the fan/3d printed bracket to the door and use the 1" 10-32 round head screw to fasten from the rear of the door.
Fan for the kit: https://amzn.to/3UtFQAi
Hardware - #10-32tpi 1" round head and nut: https://amzn.to/44Wxtlk
CA/Superglue (used for nut retention): https://amzn.to/4nXxI8p
The assembly guide is that of the smaller fan version but the steps are the same!!!
Thank you for your support!!!
Documentation (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)