Digger 2.0 by iClint %150 and LONGER ARMS

This is a remix of the original Digger 2.0 by iClint. The original can be found here: Digger 2.0 by iClint

First, all parts of the original model (original arm length ~110 mm) were scaled up to 150%.
Then, an additional 100 mm was added to the two upper arms, bringing their total length to approximately 270 mm.
This modification creates a “long-arm” version of the scaled-up digger, allowing the bucket to reach much farther while keeping all other parts compatible with the enlarged version.

Supports are only required for the bucket and pivot parts.

A step-by-step instruction manual can be found here: Instructions
 

The following tools are also required for assembly:

• Super glue
• Bulldog clips or clothespins
• Needlenose pliers
• Sandpaper (optional)
  
  Note:
  During testing, we found that the small printed pins can sometimes break under stress. As an optional alternative, you can replace them with small screws + washers (as shown in the photo). This provides a much more durable and stable connection.