Slide Shoes - Fully 3d-printed

Fully 3d printed slide shoes

• you can actually wear them and they are very comfortable due to the high sole

   

• I printed them with the BIGTREETECH MorPhlex TPU Filament, which prints at 90A and then drops to 75A, therefore you end up with a very soft and comfortable shoe but without the warping and bad print quality as other soft filaments
  • if you also want to use this filament: https://tidd.ly/4mnOVXm (affiliate link)

Important notes:

• You can adjust the hardness of the sole through the infill. For soft filament (75A), I recommend 14% or higher, and significantly less for harder filament

• It is for EU shoe size number 43 (male), but you can scale them to your size (use uniform scaling)

  

• If the shoe is too big to fit to the printers height, use the “WithSupport”-Version, rotate in Y-Axis (green) and use the cut tool in Bambu Studio to create a new flat surface parallel to the print bed
  • I uploaded an .stl file without cut ("NoCut") on the bottom for better scaling
• There are two ways to print this:
  • Use a textured PEI bed and print it standing up without support (It works very well, especially with printers where the bed is not moved so much, such as P1S, P1P X1,…)
  • Or use another not so sticky bed and print it standing up with support (recommended for A1 or similar printers)

-----------------------------

Check out my other models, for example the fully printed crocs shoes: https://makerworld.com/en/models/425034#profileId-328514

If you want to sell printed parts from my designs or want to get the .step files of my models you can become a member of my Patreon: https://www.patreon.com/c/makerversedesigns 

Have fun with it and leave a like or subscribe if you like it!

If there are any suggestions for improvement, feel free to write a comment.