Lasko Fan tilted feet for stairway

This is a foot for a Lasko Fan that is tilted for use at the base of the stairway to help circulation. 

I have used this without issue, but you should make sure to test it on the floor type, and the speed you intend, to make sure it doesn't tip over. This is inherently less stable than the fan is in its default configuration, so use at your own risk.

Printed “flat” will use the least amount of support, and it will work (which is the orientation included in the file), but it when inserting into the fan, will give resistance as the layer lines cause extra friction. 

If you print on the side, it will install easier (and will be stronger), but you will need to use the “normal” supports, not "tree" to have it properly supported.