iFlight BumbleBee / GreenHornet V2.0 Ducts (wider and taller than v1.3)

Summary

I had to make this because the v2.0 Bumblebee and Green Hornet ducts are 2 mm wider and 1mm taller compared to the v1.3 ducts that are readily available here on Thingverse.

Print Settings

Printer Brand:

FlashForge

Printer:

Creator Pro

Rafts:

Yes

Supports:

No

Infill:

100%

Notes:

Print upside down (with the notches up) and it won't need supports. All 3 notches are the same size (the OEM ones have one notch that's deeper than the other 2). I've found that using a raft keeps it from being knocked off the print bed.

How I Designed This

This also was my first build using Fusion 360 instead of Tinkercad. I'm very much still learning which is why all 3 notches are the same size, I did manage to figure out how to make the duct roughly shaped the same as the OEM one: narrower at the top and wider at the bottom. Dunno if that serves an actual purpose or not =)