Self Balancing Kinetic Sculpture
Print Profile(2)
Description
This is a self-balancing sculpture. With very little assembly.
I got the inspiration from a similar sculpture that I saw on Facebook, made from metal and stones.
Each sphere must be printed with the following infill. I know that these settings work, I have not tested a uniform infill for all spheres.
- Smallest-20%
- Small-75%
- Medium-65%
- Large-65%
The body is print-in-place. It prints in one whole piece, then the spheres have holes you insert the rods into from the body.
Under the largest sphere there is a wider tab that will insert into the base.
After that you are done, that is all the assembly that is required.
No support or hardware needed.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (27)