Bow Stanley Straw Topper - Free 3D Print Model

Search models, users, collections, and posts

Morganja

Art>Other Art Models

IP Report

Print Profile(1)

All

P1S

P1P

H2D

X1E

X1 Carbon

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

54 min

1 plate

4.9(19)

Open in Bambu Studio

Boost

272

850

324

192

Released

Description

This Stanley Straw Topper is made to fit a 10mm Stanley straws :) AND IT ALSO COMES WITH FREE COMMERCIAL USE :)

My print profile is set ready to print :)
if you enjoyed please give me a boost it doesn't cost you anything :)

Leaving a comment, boost and a picture of your print would be very much appreciated :)

Boost Me (for free)

This Stanley Straw Topper is made to fit a 10mm Stanley straws :) AND IT ALSO COMES WITH FREE COMMERCIAL USE :)

My print profile is set ready to print :)
if you enjoyed please give me a boost it doesn't cost you anything :)

Leaving a comment, boost and a picture of your print would be very much appreciated :)

free commercial license

free commercial use

free commercial use for small sellers

free commercial use small seller

free

make some money

models to sell

Comment & Rating (24)

@JadeandKano

Print Profile

0.2mm layer, 2 walls, 15% infill

was looking beautiful until it was time to remove and it was stuck solid, gutted but may try again tomorrow, thank you for the lovely profile

The profile uploader has replied

@Morganja3d

sorry about that from your photo i couldn't even tell you what happened i have seen others with success so please do try again :)

@JadeandKano

didnt come off the plate well, slightly disappointed as the print was looking awesome, trial and error I guess, may try again another day, thank you for the profile 😊

The designer has replied

@Morganja3d

sorry about that from your photo i couldn't even tell you what happened i have seen others with success so please do try again :)

@user_371863730

Print Profile

0.2mm layer, 2 walls, 15% infill

love these!

The profile uploader has replied

@Morganja3d

that's great to hear :)

@user_1378286868

Print Profile

0.2mm layer, 2 walls, 15% infill

(Edited)

@Ariasfire042

Print Profile

0.2mm layer, 2 walls, 15% infill

these came out good one at a time. When I tried to make a plate of them for gifts about half had mistakes. Not sure if it was my printer or the file. The ones that came out good are nice.