Amazfit Bip 6 Charger Stand

I always had issues with getting (and keeping) my Amazfit Bip 6 aligned and properly connected to the charging puck.

So I made this stand, the design is heavily inspired by guppyk, but remade from scratch in Fusion. Parametric files available on request. 

By creating a snug fitting body cutout, the watch now stays aligns properly on the first try and stays put.

The cutouts work for the standard band, but probably not for bands that are much wider. There is also a hole in the back that allows you to pop out the charging puck with a small allen key if needed.

I had the best results printing the stand upright with slim tree supports (for Basic PLA) on the A1 with the 0.4 nozzle, but depending on the material you may need the default supports or even put it on the side.