Arsenal Screw Top Lid Rugged Cylindrical Container

This model is a remix of the original rugged storage pot (awesome design btw slavik!) 

Here are some instructions for printing should you need them and the 3mf doesn't properly load. I had a request from a friend with the same pot originally printed by Slavik, but he wanted me to add some premier league teams to them so this is the first remix.

Bridging speed must be set lot due to the nature of how the lid is printed. I suggest somewhere between 10-20mm/s. I'm using the P1S with those speeds on the bridging and it works fine. However, you may need to tweak this dependant on which printer you have.

Start with Red on layer #1

Swap to White on layer #13 (2.12mm)

Swap to Red on layer #31 (5.00mm)

Swap to White on layer #50 (8.04mm)

Swap to Red on layer #69 (11.08mm)

Swap to White on layer #88 (14.12mm)

The next swaps will continue from the above and this is where the arsenal logo starts.

Swap to Red on layer #93 (14.92mm)

Swap to White on layer #109 (16/20mm) - this is the last swap so leave White in until the print finishes on layer #122 (17.24mm).

The concept of how i designed this was take Slavik's amazing design, but blend it with “Hueforge”. This is known as a “Hybrid Hueforge” and i have not used any svgs or vectors for this. The hueforge is printed on top of the pot using a height modifier. This was my first attempt at it but hope someone else can enjoy too.