Search models, users, collections, and posts
Schelle
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 60% infill
Designer
5.7 h
1 plate
Open in Bambu Studio
Boost
17
48
5
2
71
24
Released
Description
Content has been automatically translated.
This is a pipe clamp or sealing clamp
It has an inner diameter of 102mm
The clamp has a width of 80mm
The wall thickness is 4mm
I printed the clamp with 60% infill, 4 walls, and a brim, as well as with ASA
In my case I had to seal a hole in a downpipe
The downpipe has a 10cm diameter
I glued a part of the clamp with 2-3mm soft sealing rubber
The clamp is designed for M6 screws and M10 nuts
The opening that is bolted was designed with 4mm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (5)