Search models, users, collections, and posts
Disc Golf Bracket
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
5
13
2
0
10
7
Released
Description
Tired of your Disc falling off the mounts? I was too! My disc holder is a two-piece system with clearances modeled in for mounting with screws. Unfortunately, I can not specify which size I modeled off of since I grabbed something around the house. However, I can say these have been hanging in my non-climate-controlled garage for years over a workbench with no issue. I haven’t picked up a disc off the floor since putting these up.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)