F1 Bburago 1:43 Abyss Mirror Model Car Box

Bill of Materials:

1、Bburago 1:43 Mercedes-Benz F1 Racing Model W15 Formula Alloy Car 2024 Mercedes Hamilton-tmall.com Tmall

Pinduoduo standard version price below 50, find the cheapest yourself, the link above is for reference only

2、Abyss Mirror Thousand-Layer Mirror Material Acrylic Mirror Panel Semi-Transparent Mirror Abyss Coffee Table Flower Sea Double-Sided Mirror Irregular Customization-Taobao.com

Tell customer service: length 15cm * width 6cm * thickness 3mm, place order without payment, ask customer service to modify the price, price 12 yuan for two mirrors

3、Ultra-fine extremely narrow COB LED strip 5V smart USB interface ultra-thin 3mm faint glow LED strip self-adhesive TV ambient light-tmall.com Tmall

0.5 meter 3mm wide 5V COB LED strip + 1.5 meter USB cable + manual switch

Note: must be (3mm) (3mm) (3mm) with switch

Pinduoduo has cheaper ones, link is for reference only

4、A bottle of glue (purpose: to seal the cover plate)

5、M2.6*8 flat head flat tail self-tapping screw (the model car comes with one, no need to purchase)

Printing prerequisite: Ensure your filament is dry, otherwise the walls will have small bumps protruding, affecting aesthetics

Do not tear off the film after buying the mirror, only tear it off during assembly, and do not use your fingers, paper towels, or water to wipe it (it will scratch)

Once step 8 is completed, the car cannot be removed (if you want to remove it, the cost is to scratch the semi-transparent mirror)

(Method to remove the semi-transparent mirror: press the semi-transparent mirror and push it upwards towards the cover plate)

Installation steps: (The author is too lazy to make diagrams, please urge me in the comments)

1, First, pass the LED strip through the hole in the base

2, Take the LED strip and insert it into the small hole on the left side

3, Place the cover plate, then attach the LED strip to the cover plate (do not peel off the tape), cut off the excess LED strip on the left (the LED strip has markings, you can pull the right side of the light to adjust the length), adjust it, then remove the cover plate

4, Place the mirror (non-transparent) into the slot at the back of the box

5, Close the cover plate (seal with glue)

6, Peel off the adhesive from the LED strip and attach it to the cover plate (if the tape is not sticky enough, you can apply some glue if you have it)

7, Place the car, and screw the screw from under the base into the hole of the car

8, Carefully insert the semi-transparent mirror (transparent) above the cover plate (it might get scratched), then place it into the box

After you finish printing, please share photos in the comments, I will be very very happy, thank you all