U-lock holder
Print Profile(1)
Bill of Materials
- Spring from a pen for button x 1: Max 4mm diameter
- m6 bolts x 2: 23mm (Included with the original u-lock holder)
- m6 nuts x 2: (Included with the original u-lock holder)
Description
Boost Me (for free)
If you print and like, please consider to boost me :)
This is for the Biltema U-lock, though I assume many U-locks/ wire lock use a same holder. The original holder didn’t fit on the 40mm pipe, so I made one myself.
I used the original bolts (2x6mm m6) and a spring from an old pen (maximum 4mm in diameter). The spring length can be trimmed to fit, and I think 15-20mm should work fine.
For the locking mechanism to hold the button in place I used a piece of filament, 33mm long, which I pushed into the small hole then heated the end and pressed to secure it. Alternatively you could widen the filaments end with a plier before pushing it into the hole to act as a locking pin. The hole depth is 30mm.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)